CPA YUI 유지 관리 매뉴얼 - 페이지 7

{카테고리_이름} CPA YUI에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPA YUI 16 페이지. Hidromassage tub

MAINTENANCE MANUAL

INSTALLATION LOCATION: HOW TO CHOOSE

The installation of the SPA must be carried out in compliance with the safety standard CEI 64-8 / 7 and

subsequent amendments. When choosing the positioning, take into account that the inspection sides

(inspection doors) must always remain accessible for future maintenance. The recommended ambient

temperature for the hot tub must be between -5 ° C + 45 ° C, with a relative humidity of 20 - 80%.

The presence of trees or hedges near the tub, with possible loss of debris (eg leaves), could

cause damage to the equipment over time (not covered by warranty) and lead to more expensive

and frequent maintenance. Also evaluate the best position to safeguard one's privacy and respect

for others and the best panoramic or climatic position compatibly with local regulations. An area

exposed to the morning sun guarantees greater well-being for users.

Pay attention to the characteristics of the ground on which the support platform will be built: sandy

and unstable soils or subject to flooding could compromise the stability of the base over time and

therefore the safety conditions of the hot tub itself.

The evaporation of the water from the hot tub, in the presence of high internal temperatures, can

generate very high humidity levels in the environment: choose an environment with good

ventilation, natural or forced. Alternatively, set up an air treatment system. Damage caused by

humidity is not covered by the warranty.

Pay attention to the dimensions of the hot tub: passages, doors, steps, can be an obstacle to its

transport to the desired place.

If you install the whirlpool tub inside, it should be remembered that the tub must be easily

inspected or moved for any ordinary and extraordinary maintenance operations.

INSTALLATION LOCATION: HOW TO PREPARE

Before creating the support surface, consult the sections of the hydraulic and electrical

connections to correctly position the connections.

The correct positioning of the tub is determined by the support surface. It is not possible to insert

wedges or shims under the hot tub to level the top.

Create a base or floor in reinforced concrete that is flat and suitable for supporting the weight of

the hot tub and its guests. Check the load capacity of the installation site for a weight of 300 kg /

m2.

www.cpa-piscine.it

WARNING

YUI

pag. 7 di 16

Ver 01 – 2021-07-09