Aqua PRO VIGOH80 사용 설명서 - 페이지 2
{카테고리_이름} Aqua PRO VIGOH80에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua PRO VIGOH80 11 페이지. Heat pump pool and spa heater
페이지 인쇄Installation
Procedures
(continued)
THE UNIT MUST BE TRANSPORTED IN THE UP-
RIGHT POSITION AT ALL TIMES AND MUST
NOT BE DROPPED OR TAILGATED. DAMAGE
TO THE UNIT DURING TRANSPORTATION
IS NOT THE RESPONSIBILITY OF THE
MANUFACTURER. IF UNIT IS CLOSER THAN
18 INCHES, THE MANUFACTURER IS NOT
RESPONSIBLE FOR BAD, WORN OR SEIZED
FAN MOTORS AND CAPACITORS.
UNIT LOCATION
If unit is closer
than 18 inches, the
manufacturer is not responsible for bad,
worn or seized fan motors and capacitors.
Figure 2 - Recommended
installation layout
Figure 1 -
Unit Location
NOTE: This type of constant watering
directly on the unit can void your
warranty.
UNITS WILL HAVE CONDENSATION.
THIS SHOULD NOT BE MISTAKEN FOR
A LEAK IN THE UNIT.
PLUMBING
HEAT PUMPS ARE TO BE INSTALLED OUTSIDE.
NO CHEMICAL TANKS SHOULD BE LOCATED
WITHIN 5 FT. OF THE HEAT PUMP.
2
Draining is necessary to prevent
damage to the condenser shell and coil
due to the expansion of freezing water.
Intentional setting of the water FLow
outside of these guidelines will void
ALL
the warranty.
NOTE: Do not place chlorine tablets,
or any other chemicals directly in
skimmer basket. Doing this will void
the warranty.
ELECTRICAL CONNECTIONS
must be performed by a qualified
electrician. Installations must be in
accordance with local and national codes.
IF INSTALLING MORE THAN
ONE UNIT, CALL TO GET ALL
INSTALLATION SPECS
All wiring and
electrical connections