Aqua PRO ECO550 설치 및 사용자 설명서 - 페이지 10

{카테고리_이름} Aqua PRO ECO550에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua PRO ECO550 20 페이지. Swimming pool heat pump
Aqua PRO ECO550에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (20 페이지)

페이지 인쇄

bracket must be strong and antirust treated;

3) Don't stack substances that will block air flow near inlet or outlet area,

and no barrier within 20in behind the main heater, or the efficiency

of the heater will be reduced or even halted;

4) The heater needs an appended pump (Supplied by the user). The

recommended pump specification-flux: refer to Technical Parameter,

Max. lift ≥10m;

5) When the heater is running, there will be condensation water

discharged from the bottom. Please hold the drainage nozzle

(accessory) into the hole and attach it well, then connect a pipe to

drain the condensation water out.

B. Wiring

1) Connect to appropriate power supply; the voltage should comply

with the rated voltage of the products.

2) Heater must be grounded.

3) Wiring must be handled by a professional technician according to

the circuit diagram.

4) Set leakage protector according to the local code for wiring (leakage

operating current ≤ 30mA).

5) The layout of power cable and signal cable should be orderly and

not interfere with each other.

6) The appliance shall be installed in accordance with national wiring

regulations.

C. Switch on after finishing all wiring construction and

re-checking.