CPE 100189 사용 설명서 및 작동 지침 - 페이지 9

{카테고리_이름} CPE 100189에 대한 사용 설명서 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CPE 100189 16 페이지. Bike carrier

100189

ENGLISH

NOTE

Remove hardware already in the support base prior to

any assembly or inserting tube .

NOTE

Grease can be applied to the plastic spacers if needed

for grip upon reinsertion of hardware and tube .

Assemble the primary (1-2 bike) frame, by taking the

support base assembly (A) and connecting the horizontal

tube (H) using two cap screws (N), lock nuts (P), flat

washers (L), and four plastic spacers (O) . Make sure

the bolt on the end of the horizontal tube is facing up .

Be sure to re-insert the two (2) plastic spacers inside

of support base before inserting square horizontal tube .

Align two small pins into the holes provided .

NOTE

1 . The primary support base frame will NOT have a

reflector at the end of the tube .

Attach the primary (1-2 bike) support base assembly to

hitch mounting assembly (D) . Be sure to insert plastic

spacers (R) into square tube before attaching to hitch

mounting assembly using screw M12x80 (Q) and lock nut

M12 (S) . Use metal strap and pin Ø8 x 85 mm and pin

Ø12 .6 x 8 mm for extra safety .

Assembling the bike carrier cont'd.

2 . Insert plastic spacers (2) onto each side of square

tube prior to assembly to hitch mounting assembly

assembly .

Make sure the centre bar is in the upright and locked

position . Slide the notched key slide into the centre hole

and turn to ensure it's locked . Using your hand or a

phillips head screw driver (not included), unscrew the bolt

on the ends of the horizontal tubes .

Slide the wheel cradles (B+C) onto the horizontal tubes

(A+H) . Adjustment knob should be facing up . Loop end

of cradle should be facing outward and upward . Insert

cradles in sequence as shown below . After all 4 cradles

are on the horizontal tubes, replace the end bolts and

tighten using a phillips head screwdriver (not included) .

NOTE

ASSEMBly