CPE 100189 사용 설명서 및 작동 지침 - 페이지 11

{카테고리_이름} CPE 100189에 대한 사용 설명서 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CPE 100189 16 페이지. Bike carrier

100189

ENGLISH

Mounting the Bike Carrier

NOTE

Remove any debris to ensure no blockage is in the

receiver .

If you are mounting to a 3 .6 cm (1 1/4 in .) receiver hitch,

remove the hex socket screw connecting the 5 . 1 cm (2 in .)

receiver adapter, with the allen wrench provided .

After removal of the 5 . 1 cm (2 in .) receiver adapter,

connect the bike carrier using the screw M12x95 mm with

end hole and washers and R-Pin .

If you are mounting to a 5 . 1 cm (2 in .) receiver then mount

the bike carrier using the using the 5 . 1 cm (2 in .) receiver

adapter, screw M12x95 mm with end hole and washers

and R-Pin .

Mounting the bikes

The wheel cradles and J-hooks are completely adjustable

and slide on the tubes . Using the vertical knobs on

the tops of the cradles and the horizontal knobs on the

J-hooks, twist them unit they are loose and the cradle or

J-hook can move on the tube .

Once adjusted to allow the bike to properly fit into the

cradles, load the bike wheels directly into the cradles and

ensure they will not roll back and forth . Bring down the

J-hook till it is snuggly fit over the middle part of the frame

on the bike . Twist the side knob to secure the position

of the J-hook . Use the strap on the cradles to secure the

wheels . Adjust the strap as needed per each wheel . Make

sure all wheels have a strap securing them .

NOTE

Drive for a short amount, stop inspect that the

bikes are still securely mounted .Always inspect all

mounting hardware before use or mounting .

MOUNTING