CPE 100189 Owner's Manual & Operating Instructions - Page 11

Browse online or download pdf Owner's Manual & Operating Instructions for Bicycle Accessories CPE 100189. CPE 100189 16 pages. Bike carrier

Print Page

100189

ENGLISH

Mounting the Bike Carrier

NOTE

Remove any debris to ensure no blockage is in the

receiver .

If you are mounting to a 3 .6 cm (1 1/4 in .) receiver hitch,

remove the hex socket screw connecting the 5 . 1 cm (2 in .)

receiver adapter, with the allen wrench provided .

After removal of the 5 . 1 cm (2 in .) receiver adapter,

connect the bike carrier using the screw M12x95 mm with

end hole and washers and R-Pin .

If you are mounting to a 5 . 1 cm (2 in .) receiver then mount

the bike carrier using the using the 5 . 1 cm (2 in .) receiver

adapter, screw M12x95 mm with end hole and washers

and R-Pin .

Mounting the bikes

The wheel cradles and J-hooks are completely adjustable

and slide on the tubes . Using the vertical knobs on

the tops of the cradles and the horizontal knobs on the

J-hooks, twist them unit they are loose and the cradle or

J-hook can move on the tube .

Once adjusted to allow the bike to properly fit into the

cradles, load the bike wheels directly into the cradles and

ensure they will not roll back and forth . Bring down the

J-hook till it is snuggly fit over the middle part of the frame

on the bike . Twist the side knob to secure the position

of the J-hook . Use the strap on the cradles to secure the

wheels . Adjust the strap as needed per each wheel . Make

sure all wheels have a strap securing them .

NOTE

Drive for a short amount, stop inspect that the

bikes are still securely mounted .Always inspect all

mounting hardware before use or mounting .

MOUNTING