CPE 100189 Kullanıcı El Kitabı ve Kullanım Talimatları - Sayfa 11
Bisiklet Aksesuarları CPE 100189 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı ve Kullanım Talimatları indirin. CPE 100189 16 sayfaları. Bike carrier
Sayfayı Yazdır100189
ENGLISH
Mounting the Bike Carrier
NOTE
Remove any debris to ensure no blockage is in the
receiver .
If you are mounting to a 3 .6 cm (1 1/4 in .) receiver hitch,
remove the hex socket screw connecting the 5 . 1 cm (2 in .)
receiver adapter, with the allen wrench provided .
After removal of the 5 . 1 cm (2 in .) receiver adapter,
connect the bike carrier using the screw M12x95 mm with
end hole and washers and R-Pin .
If you are mounting to a 5 . 1 cm (2 in .) receiver then mount
the bike carrier using the using the 5 . 1 cm (2 in .) receiver
adapter, screw M12x95 mm with end hole and washers
and R-Pin .
Mounting the bikes
The wheel cradles and J-hooks are completely adjustable
and slide on the tubes . Using the vertical knobs on
the tops of the cradles and the horizontal knobs on the
J-hooks, twist them unit they are loose and the cradle or
J-hook can move on the tube .
Once adjusted to allow the bike to properly fit into the
cradles, load the bike wheels directly into the cradles and
ensure they will not roll back and forth . Bring down the
J-hook till it is snuggly fit over the middle part of the frame
on the bike . Twist the side knob to secure the position
of the J-hook . Use the strap on the cradles to secure the
wheels . Adjust the strap as needed per each wheel . Make
sure all wheels have a strap securing them .
NOTE
Drive for a short amount, stop inspect that the
bikes are still securely mounted .Always inspect all
mounting hardware before use or mounting .
MOUNTING
11