CPE 100189 Owner's Manual & Operating Instructions - Page 10

Browse online or download pdf Owner's Manual & Operating Instructions for Bicycle Accessories CPE 100189. CPE 100189 16 pages. Bike carrier

Print Page

ASSEMBly

Assembling the bike carrier cont'd.

Install long J-hook assembly (E) and short J-hook

assembly (F) onto the centre bar . Twist the side knobs to

untighten/tighten and allow the J-hooks to slide up and

down the centre bar .

NOTE

3 . When tightening "J-hooks" make sure there is

no gap in the bottom adjuster . The bottom knob

adjuster is "spring" loaded and must be tightened all

the way to ensure safety .

WARNING

J-hooks must NOT slide all the way down on the

centre bar . This will prevent the bar from going all

the way down on either side and locking for proper

storage .

If only using the primary (1-2) bike frame, ensure a

reflector (X) is inserted firmly into the hollow end before

street/road use . Do not insert if using the 3-4 bike frame .

If transporting 3 or 4 bicycles, build the secondary bike

frame the same as the primary (1-2) bike frame . Then

attach the secondary bike frame assembly to the main

hitch assembly using the extension tube (G) .

Assembling the bike carrier cont'd.

First attach the extension tube (G) to the primary bike

frame, using screw M12x70 with end hole (J), flat washer

Ø13, flat washer Ø10 (K, L) & R-pin (M) .

Then attach the secondary frame to the extension tube

using the plastic spacers (R) into square tube before

threading through screw M12x70 with end hole (J) flat

washer Ø13, flat washer Ø10 (K, L) & R-pin (M) . Tighten

securely .

100189

ENGLISH