DFM CFB16 운영자 매뉴얼 - 페이지 14

{카테고리_이름} DFM CFB16에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFM CFB16 20 페이지.

페이지 인쇄

Attaching the Feller Buncher

Mounting the unit to the carrier consists of 3 steps;

failure to follow these steps may result in the unit

disengaging from the carrier, causing injury or death.

STEP 1: The Mounting Plate

The CFB16 is equipped with a universal mounting plate;

to attach the unit, drive the carrier toward the plate,

hook the plate with the carriers brackets, and roll the

carriers brackets backwards. After the operator has

successfully "hooked" the brackets onto the plate, the

operator then engages the brackets lock function. The

operator must then visually confirm the lock function has

been successfully engaged.

STEP 2: Connecting the Hydraulics

The next step is to connect the hydraulic hoses from

the unit to the carrier's auxiliary ports. CFB16 ships with

the correct hydraulic couplers for use on the carrier

specified. Standard flow units make use of 2 hoses to

operate,

igh flow models require a 3rd hose, acting as

a case drain to relieve excess back pressure. CASE

DRAIN LINE MUST BE ATTACHED AT ALL TIMES

WHEN IN USE, FAILURE TO DO SO WILL RESULT IN

DAMAGE TO THE HYDRAULIC SYSTEM, AND VOID

WARRANTY

The operator must line up the units couplers with the

correct couplers on the carrier side, and snap them into

place; the operator then rotates the couplers collar ¼

turn to engage the couplers lock function. Operator should

then visually confirm the couplers are all attached, and the

lock functions have been engaged.

STEP 3: Connecting the Electronics

The 3rd step is to hook up the electrical system. The CFB16

makes use of an electric over hydraulic circuit to engage

certain valves required to function properly, This

ship with one of two options. Option 1: for carriers with a

pin connection system the unit will ship with a pin connector,

and will utilize the carriers own joystick buttons to operate.

To hook up this option, the operator will plug the pin

connector into the carrier side socket. Option 2: for units

not equipped with pin connection system; the unit will ship

with a wiring harness; this wiring harness will contain 4

sealed buttons, connection plugs, and a length of electrical

wire; to hook up this option the operator will need to tap

into a 12 volt source, as well as attach the buttons in cab in a

convenient location. (See Diagram)

Wiring Diagram

Green ––––– Accumulator Arm - Open Function

Yellow ––––– Accumulator Arm - Close Function

Brown –––––––––– Grapple Arms - Open Function

Blue –––––––––– Grapple Arms - Close Function

Black ––––––––––––––––––––––––––––––Ground

Attaching the Feller Buncher | 8

nit will