AVS Electronics VECTOR Plus 설치 매뉴얼 - 페이지 7

{카테고리_이름} AVS Electronics VECTOR Plus에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVS Electronics VECTOR Plus 12 페이지. Bidirectional gsm interface

페이지 인쇄

GSM engine connection

Modulo

GSM engine

GSM

Connect the GSM engine to 30 pin female connector.

Plugging in sim card / antenna jack

Ingresso connettore antenna

Input antenna jack

SW1

PROG.

RESET

PB2

RV5

F1 F3.15A L250V

F2 F3.15A L250V

BATT.

GSM engine with upper side SIM Card holder:

1. Press pushbutton A.

2. Extract B holder.

3. Put SIM card on B.

4. Insert B holder all the way long into its receptacle.

GSM engine with right side SIM Card holder:

To insert SIM Card:

1. Insert SIM Card completely into slot C until it clicks inside

the module

To remove SIM Card:

1. Press and release the SIM Card to cause it to be ejected

through the slot.

RV1

RV2 RV3

RV4

TAMPER

PB1

A B

GSM

OUT STATE

TAMPER

CENTR.

Antenna jack:

Place the male connector of the antenna

cable into the female one of the module

and apply slight pressure in the axis

direction to click it into the module. Do not

force or bend the cable sideway. To

remove the cable, hold the connector with

the fingertips and pull avoiding bending it

sideway. Do not pull the cable.

Display module connection

Remove power from the interface and

insert the display module into the proper

connectors as indicated in the figure.

CENTR.