DFRobot Light Chaser 매뉴얼 - 페이지 5

{카테고리_이름} DFRobot Light Chaser에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFRobot Light Chaser 14 페이지. Beginner soldering kit

Step5

Clip off all excess wire

so that only the tiny

solder joints remain.

Step6

Resistance soldering

completed.

WARNING: Please wear safety goggles.

This kit requires soldering and clipping leads.

Making the head

20K

20K Ohm Resistor

Used for limiting current or dividing voltage, a resistor is a common

component within circuits. Just solder the resistors to its proper

position on the board (shown in the diagram), regardless of the

electrode being positive or negative.

1. Solder the resistors

20K

After soldering, cut off the

remaining length of the wire.

20K