DFRobot Light Chaser 매뉴얼 - 페이지 7

{카테고리_이름} DFRobot Light Chaser에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFRobot Light Chaser 14 페이지. Beginner soldering kit

4-Soldering Light

Chaser Kit V1

The photodiode is a component that changes a light signal into a

current or voltage signal. It is highly sensitive to light intensity, and

can be used to change a circuit's current. Insert the photodiodes

into the front of the board. Each photodiode has a short leg and a

long leg. The long leg goes into the hole labeled with a long line.

4. Solder the photodiodes

After soldering, cut off the

remaining length of the wire.

Photodiode(S8050)

Place the photodiode into the front side of the board. Then,

bend the photodiode into a 90 degree angle (see picture),

making sure to leave around 25mm at the base of the diode.

Flip the board over and solder the joints.