DFRobot Light Chaser 매뉴얼 - 페이지 8
{카테고리_이름} DFRobot Light Chaser에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFRobot Light Chaser 14 페이지. Beginner soldering kit
페이지 인쇄4-Soldering Light
Chaser Kit V1
Battery Clip
The battery clip is for holding the coin cell battery. Set the battery
clip on the white footprint of the upper side of the board. Solder the
two clip legs from the opposite side while keeping the part flat.
5. Solder the
Battery Clip
The vibration motor provides the power source that enables Mr. NEON
to happily hum along. Solder the motors into the front of the board.
The red leg goes into the hole labeled "+".
6. Solder the
4-Soldering Light
vibration motors
Chaser Kit V1
After soldering, cut off
the remaining length of
the wire.
Vibration Motor