DFRobot Light Chaser Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} DFRobot Light Chaser. DFRobot Light Chaser 14 pagina's. Beginner soldering kit

Pagina afdrukken
4-Soldering Light
Chaser Kit V1
Battery Clip
The battery clip is for holding the coin cell battery. Set the battery
clip on the white footprint of the upper side of the board. Solder the
two clip legs from the opposite side while keeping the part flat.
5. Solder the
Battery Clip
The vibration motor provides the power source that enables Mr. NEON
to happily hum along. Solder the motors into the front of the board.
The red leg goes into the hole labeled "+".
6. Solder the
4-Soldering Light
vibration motors
Chaser Kit V1
After soldering, cut off
the remaining length of
the wire.
Vibration Motor