DG TOE10G-IP 설정 매뉴얼 - 페이지 7
{카테고리_이름} DG TOE10G-IP에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DG TOE10G-IP 18 페이지. Fpga setup with cpu demo
페이지 인쇄dg_toeudp10gip_fpgasetup_intel.doc
The step to setup test environment by using FPGA and PC is described in more details as
follows.
1) Turn off power switch and connect power supply to FPGA board.
2) Connect micro USB cable from FPGA board to PC for JTAG programming and JTAG
UART.
3) Connect 10Gb Ethernet cable between FPGA board and PC.
a) For every board except Stratix10 GX board, insert 10 Gb SFP+ DAC (Length<1m),
AOC or SFP+ transceiver with LC-LC cable) between FPGA board and PC.
b) For Stratix10 GX board, insert QSFP+ to 4 SFP+ cable between FPGA board and PC.
Use SFP+ no.1 to connect to QSFP1, connector on the right side, as shown in
26-Aug-20
Figure 1-5 Power connection and microUSB connection
Figure 1-6 10Gb Ethernet connection
Page 7