Avtec Scout NENA 구성 매뉴얼 - 페이지 5

{카테고리_이름} Avtec Scout NENA에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtec Scout NENA 15 페이지. Deskset for hardware media workstation

Installing the Jack Box

Connectors located on the rear of the Media Workstation Plus provide for headset jack boxes, desktop microphone,

dual or single footswitches, select and unselect speakers, call recorders, and a connection for four auxiliary control

relays.

NOTE

The Avtec USB NENA Jack Box's NENA port does not presently support receiving sidetone from external devices

that generate sidetone.

To install a jack box:

1. Plug the connector into any AP Port Type I port on the Media Workstation Plus.

2. From the Console Configuration webpage, select Audio Devices.

The Audio Devices page displays.

3. Click Add to add and configure available jack boxes.

After installing the hardware components, you must perform a series of software configuration steps to enable the jack

box and external audio interface. This configuration occurs in Scout Manager, as well as on the Avtec Hardware Media

Workstation Jack Box and Hardware media Workstation External Audio Interface webpages.

Complete the following tasks to configure the specific settings that allow the jack box to operate with Scout. The

sections that follow provide instructions for performing these tasks.

Configuring a 12xx Jack Box

Configuring the External Audio Interface

Configuring the Endpoint for the E911 Deskset

Creating a Line Pad for an E911 Deskset Endpoint

Configuring an 1101 Jack Box

Perform the following steps to add and configure an 1101 series jack box using Scout Manager:

1. Access Scout Manager > Console Configuration webpage > Audio Devices tab.

2. In the New Device dropdown, select 1101 Jack Box.

3. Click Add.

The 1101 jack box configuration page displays.

NENA/Deskset for Hardware Media Workstation | November 2020 | Revision 8

Phone: 1-803.358.3600 • Fax: 1-803.358.3636

100 Innovation Place • Lexington SC 29072 USA