Avtec Scout NENA Посібник з конфігурації - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з конфігурації для Робочий стіл Avtec Scout NENA. Avtec Scout NENA 15 сторінок. Deskset for hardware media workstation
Друкувати сторінку- 1. Table of Contents
- 2. NENA Radio/Telephone Headset Interface
- 3. Installing the Jack Box
- 4. Software Configuration
- 4. Configuring an 1101 Jack Box
- 4. Configuring a 12Xx/50Xx Jack Box
- 4. Configuring the External Audio Interface
- 4. Configuring the Endpoint for the E911 Deskset
- 4. Creating a Line Pad for an E911 Deskset Endpoint
- 5. Using an E911 Deskset
- 6. Appendix A: What Does It Mean to be NENA-Compliant
- 7. Appendix B: Understanding the Physical Connections
Installing the Jack Box
Connectors located on the rear of the Media Workstation Plus provide for headset jack boxes, desktop microphone,
dual or single footswitches, select and unselect speakers, call recorders, and a connection for four auxiliary control
relays.
NOTE
The Avtec USB NENA Jack Box's NENA port does not presently support receiving sidetone from external devices
that generate sidetone.
To install a jack box:
1. Plug the connector into any AP Port Type I port on the Media Workstation Plus.
2. From the Console Configuration webpage, select Audio Devices.
The Audio Devices page displays.
3. Click Add to add and configure available jack boxes.
Software Configuration
After installing the hardware components, you must perform a series of software configuration steps to enable the jack
box and external audio interface. This configuration occurs in Scout Manager, as well as on the Avtec Hardware Media
Workstation Jack Box and Hardware media Workstation External Audio Interface webpages.
Complete the following tasks to configure the specific settings that allow the jack box to operate with Scout. The
sections that follow provide instructions for performing these tasks.
1.
Configuring an 1101 Jack Box
2.
Configuring a 12xx Jack Box
3.
Configuring the External Audio Interface
4.
Configuring the Endpoint for the E911 Deskset
5.
Creating a Line Pad for an E911 Deskset Endpoint
Configuring an 1101 Jack Box
Perform the following steps to add and configure an 1101 series jack box using Scout Manager:
1. Access Scout Manager > Console Configuration webpage > Audio Devices tab.
2. In the New Device dropdown, select 1101 Jack Box.
3. Click Add.
The 1101 jack box configuration page displays.
NENA/Deskset for Hardware Media Workstation | November 2020 | Revision 8
Phone: 1-803.358.3600 • Fax: 1-803.358.3636
100 Innovation Place • Lexington SC 29072 USA
avtecinc.com • [email protected]
2