Allied Telesis AT-WR4662n 명령 참조 매뉴얼 - 페이지 10

{카테고리_이름} Allied Telesis AT-WR4662n에 대한 명령 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-WR4662n 16 페이지. High-speed mobility wireless base router
Allied Telesis AT-WR4662n에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (2 페이지)

페이지 인쇄

Common setup

Enter the following commands to restore the factory configuration for bridged mode:

AT-WR4600# copy nvram:/factory-config-routed startup-config

AT-WR4600# reload

Configure the common SSID for open authentication:

AT-WR4600(config)# dot11 ssid ATIopen

AT-WR4600(config-ssid)# authentication open

AT-WR4600(config-ssid)# guest-mode

AT-WR4600(config-ssid)# exit

Note: In this example network, each node belongs to a different wired LAN (subnet). You may build

the same wireless service using bridged mode, so that all nodes are all in the same subnet.

[P1] station role: root access-point

Configure the station role; assign the IP address and the SSID to the radio interface:

AT-WR4600(config)# interface dot11radio 0

AT-WR4600(config-if)# station-role root access-point

AT-WR4600(config-if)# ip address 10.0.0.100/24

AT-WR4600(config-if)# ssid ATIopen

AT-WR4600(config-if)# no shutdown

AT-WR4600(config-if)# end

[STA1] station role: workgroup-bridge

Configure the station role; assign the IP address and the SSID to the radio interface:

AT-WR4600(config)# interface dot11radio 0

AT-WR4600(config-if)# station-role workgroup bridge

AT-WR4600(config-if)# ip address 10.0.0.1/24

AT-WR4600(config-if)# ssid ATIopen

AT-WR4600(config-if)# no shutdown

AT-WR4600(config-if)# end

[STA2] station role: workgroup-bridge

Configure the station role; assign the IP address and the SSID to the radio interface:

AT-WR4600(config)# interface dot11radio 0

AT-WR4600(config-if)# station-role workgroup bridge

AT-WR4600(config-if)# ip address 10.0.0.2/24

AT-WR4600(config-if)# ssid ATIopen

AT-WR4600(config-if)# no shutdown

AT-WR4600(config-if)# end

PN 613-001765 Rev.A