Dell 1555 - Studio - Chainlink 서비스 매뉴얼 - 페이지 25
{카테고리_이름} Dell 1555 - Studio - Chainlink에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 1555 - Studio - Chainlink 50 페이지.
Dell 1555 - Studio - Chainlink에 대해서도 마찬가지입니다: 서비스 매뉴얼 (50 페이지)
페이지 인쇄
1 screws (4) 2 hard drive bracket
CAUTION:
When the hard drive is not in the computer, store it in protective antistatic packaging. For more information, see "Protecting Against
Electrostatic Discharge" in the safety information that shipped with your computer.
Replacing the Hard Drive
1. Follow the instructions in
Before You
2. Replace the hard drive bracket and tighten the four screws to secure the bracket to the hard drive.
3. Place the hard drive assembly in the computer base.
4. Slide in the hard drive assembly to make contact with the hard drive connector.
5. Replace the four screws that secure the hard drive assembly to the computer base.
6. Replace the base cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
Do not follow the operating system installation process if the hard drive is a Factory-Imaged Hard Drive (FIHD). The operating system
is already installed in the FIHD.
7. Install the operating system for your computer, as needed (see the Dell Technology Guide).
8. Install the drivers and utilities for your computer, as needed (see the Dell Technology Guide).
Back to Contents Page
Begin.
Replacing the Base
Cover).