Allied Telesis AT-IMC100T/SCMM 설치 매뉴얼 - 페이지 12
{카테고리_이름} Allied Telesis AT-IMC100T/SCMM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-IMC100T/SCMM 20 페이지. Fast ethernet industrial media converter
페이지 인쇄
Hardware Description
2.7 Ports
RJ-45 ports (Auto MDI/MDIX): The RJ-45 ports are auto-sensing for 10Base-T or 100Base-TX devices connections. Auto
MDI/MDIX means that you can connect to another switch or workstation without changing straight through or crossover
cabling. See figures as below for straight through and crossover cable schematic.
2.7.1 RJ-45 Pin Assignments
Pin Number
Assignement
1
Tx+
2
Tx-
3
Rx+
6
Rx-
Note:
"+" and "-" signs represent the polarity of the wires that make up each wire pair.
All ports on this unit support automatic MDI/MDI-X operation, you can use straight-through cables (See Figure below) for all
network connections to PCs or servers, or to other switches or hubs. In straight-through cable, pins 1, 2, 3, and 6, at one
end of the cable, are connected straight through to pins 1, 2, 3 and 6 at the other end of the cable. The table below shows
the 10BASE-T/ 100BASE-TX MDI and MDI-X port pin outs.
Pin MDI-X
Signal Name
1
Receive Data plus (RD+)
2
Receive Data minus (RD-)
3
Transmit Data plus (TD+)
6
Transmit Data minus (TD-)
Switch
3 TD+
6 TD-
1 RD+
2 RD-
AT-IMC100T/SCSM and AT-IMC100T/SCMM Fast Ethernet Industrial Media Converters
MDI Signal Name
Transmit Data plus (TD+)
Transmit Data minus (TD-)
Receive Data plus (RD+)
Receive Data minus (RD-)
Router or PC
3 TD+
6 TD-
1 RD+
2 RD-
Ports
12