Dell Inspiron 1320 서비스 매뉴얼 - 페이지 32

{카테고리_이름} Dell Inspiron 1320에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1320 46 페이지. Dell inspiron inspiron 13: specifications
Dell Inspiron 1320에 대해서도 마찬가지입니다: 설정 및 기능 매뉴얼 (12 페이지), 제품 안전 데이터 시트 (6 페이지)

페이지 인쇄

Back to Contents Page

Memory Module(s)

Dell™ Inspiron™ 1320 Service Manual

Removing the Memory Module(s)

Replacing the Memory Module(s)

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™

is not covered by your warranty.

CAUTION:

To help prevent damage to the system board, remove the main battery (see

computer.

You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the

memory supported by your computer. Install only memory modules that are intended for your computer.

NOTE:

Memory modules purchased from Dell are covered under your computer warranty.

Your computer has two user-accessible SODIMM socket that can be accessed from the bottom of the computer.

Removing the Memory Module(s)

1. Follow the procedures in

Before You

2. Remove the battery (see

Removing the

3. Remove the module cover (see

CAUTION:

To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.

4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.

5. Remove the memory module from the memory module connector.

memory module connector

securing clips (2)

Replacing the Memory Module(s)

1. Align the notch in the memory module with the tab in the memory module connector.

Begin.

Battery).

Removing the Module

Cover).

memory module

Removing the

Battery) before working inside the