Dell Latitude 3000 Series 서비스 매뉴얼 - 페이지 23

{카테고리_이름} Dell Latitude 3000 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Latitude 3000 Series 43 페이지. 2-in-1
Dell Latitude 3000 Series에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사용자 설명서 (9 페이지), 유틸리티 및 드라이버 설치 (4 페이지), 사양 (6 페이지), 기술 매뉴얼북 (45 페이지), 사양 (2 페이지), 시작하기 매뉴얼 (28 페이지), 설치 지침 (1 페이지), 빠른 시작 매뉴얼 (2 페이지), 설정 및 사양 (21 페이지), 매뉴얼 (25 페이지)

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

1. Follow the procedures in

Before You

2. Disconnect the cooling fan power cable from the fan connector on the system board.

3. Disconnect the power cable from the processor power connector on the system board.

4. Lift up the airflow shroud.

CAUTION:

The heat sink can get very hot during normal operation. Be sure that the heat sink has had sufficient time to cool before you touch it.

5. Remove the microprocessor heat sink:

a. Twist the heat sink from side to side to break the seal.

b. Pull the release tab out until the heat sink is released.

c. Lift the heat sink away from the microprocessor.

d. On the retention base, locate the tab opposite the power supply. Press on the retention base tab until the heat sink pops up slightly.

e. Press out on the second retention tab while lifting the heat sink up and out of the retention base.

NOTICE:

Lay the heat sink down on its side.

NOTICE:

If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not installing a processor upgrade kit from Dell,

reuse the original heat sink and blower when you install your new processor.

6. Push down and out on the socket release lever.

7. Open the processor cover.

Begin.