Avtech DG206X 사용자 설명서 - 페이지 7
{카테고리_이름} Avtech DG206X에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech DG206X 7 페이지. Ir bullet camera
페이지 인쇄MENU
FUNC. SET
MOTION
DETECTON*
PRIVACY
SYSTEM SETUP
RESET
FACTORY MODE
SAVE & EXIT
SAVE & EXIT
* The function here is for this camera only, and the detection log will be not noted in the DVR.
FAQ
Q:
The image quality at night is not good. I can see some red dots at the edge of the image. What should I do?
A:
Please go to the camera's parameter setting page as described in the section of "CAMERA PARAMETERS", and select
EXPOSURE -> AGC to change the value to MIDDLE, and check again.
DESCRIPTION
Select ON to enable motion detection or OFF to disable this
SCREEN
ALARM
function.
No function.
PAD OUTPUT
Select the area for motion detection.
SECTION
Select the sensitivity for motion detection from LOW, MIDDLE and
SENSITIVITY
HIGH.
You'll see a default masking area on the screen.
Select ON / OFF to enable / disable this function.
MASKING
COLOR
Select a color to show area masking.
HEIGHT /
Set the area to mask.
WIDTH /
LEFT /
RIGHT /
TOP /
BOTTOM
OSD COLOR
Select the color for this OSD display.
OSD BG
Select the background color for this OSD display.
Enable to restore the camera parameters to factory default values.
The camera image will flash once when the reset is done.
Select YES to save and exit, or select NO to exit without saving.