Dell PowerEdge 2550 설치 매뉴얼 - 페이지 6
{카테고리_이름} Dell PowerEdge 2550에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2550 32 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2550에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 구성 매뉴얼 (10 페이지), 랙 설치 지침 (40 페이지), 활성화 매뉴얼 (32 페이지), 매뉴얼 (28 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
Slide the peripheral bay toward the back of the system approximately 2.5 cm
7
(one inch), and then lift the peripheral bay upward and set it aside.
If the peripheral bay is empty, remove the rectangular plastic insert from the front of
8
the system chassis.
From the inside of the chassis, push outward on the center of the plastic insert to
9
release the insert from the chassis.
If a tape drive or other drive is installed in the peripheral bay, release the drive by
10
pressing the front of each drive rail, and slide the drive out of the bay.
Slide the hard-disk drive cage into the peripheral bay until the rails snap into place
11
(see Figure 1-3).
Lower the peripheral bay back into the chassis, and then slide the bay forward into
12
position.
Be careful to avoid trapping power or interface cables underneath the peripheral bay
when you reinstall it.
Secure the peripheral bay by tightening the thumbscrew at the back corner of the cage.
13
Connect the SCSI interface cable (see Figure 1-1) to the SCSI cable connector on the
14
fifth-drive backplane board at the back of the hard-disk drive cage (see Figure 1-4).
F i g u r e 1 - 4 . C o n n e c t o r s o n t h e F i f t h - D r i v e B a c k p l a n e B o a r d
SCSI cable connector
1-4
Instal ling a Fif t h SC SI Hard- Di sk Dri ve
power connector
interface cable connector