Dell PowerEdge 2550 Installation Manual - Page 6

Browse online or download pdf Installation Manual for Laptop Dell PowerEdge 2550. Dell PowerEdge 2550 32 pages. Wake-on-lan (wol) support on dell servers
Also for Dell PowerEdge 2550: Installation Manual (26 pages), Install Manual (32 pages), Configuration Manual (10 pages), Rack Installation Instructions (40 pages), Activation Manual (32 pages), Manual (28 pages), Manual (15 pages)

Print Page
Dell PowerEdge 2550 Installation Manual
Slide the peripheral bay toward the back of the system approximately 2.5 cm
7
(one inch), and then lift the peripheral bay upward and set it aside.
If the peripheral bay is empty, remove the rectangular plastic insert from the front of
8
the system chassis.
From the inside of the chassis, push outward on the center of the plastic insert to
9
release the insert from the chassis.
If a tape drive or other drive is installed in the peripheral bay, release the drive by
10
pressing the front of each drive rail, and slide the drive out of the bay.
Slide the hard-disk drive cage into the peripheral bay until the rails snap into place
11
(see Figure 1-3).
Lower the peripheral bay back into the chassis, and then slide the bay forward into
12
position.
Be careful to avoid trapping power or interface cables underneath the peripheral bay
when you reinstall it.
Secure the peripheral bay by tightening the thumbscrew at the back corner of the cage.
13
Connect the SCSI interface cable (see Figure 1-1) to the SCSI cable connector on the
14
fifth-drive backplane board at the back of the hard-disk drive cage (see Figure 1-4).
F i g u r e 1 - 4 . C o n n e c t o r s o n t h e F i f t h - D r i v e B a c k p l a n e B o a r d
SCSI cable connector
1-4
Instal ling a Fif t h SC SI Hard- Di sk Dri ve
power connector
interface cable connector