ABB 2TLA020009R2500 원본 사용 설명서 - 페이지 5

{카테고리_이름} ABB 2TLA020009R2500에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB 2TLA020009R2500 20 페이지. Safety light beam

Overview

The light beam is available in two versions: Spot 10 for distances up to 10 m and Spot 35 for up to 35 m. The light

beams can be mounted at different heights and be angled around a machine using ABB/Jokab Safety mirrors and

brackets.

The combination of Spot and Vital 1 fulfils the requirements for Category 4/PL e according to EN 954-1/EN ISO

13849 and type 4 according to EN 61496. Several light beams, Eden sensors and emergency stops can be

connected in series and still achieve PL e for the safety circuit. A number of solutions for bypassing of light beams

for material transport are available.

For indication there are LEDs on the transmitter and on the receiver which indicate 'contact' between transmitter

and receiver, as well as the safety status. The 'contact' information is available via the light beam receiver

connection cables.

Shielded cable is recommended between this unit and the rest of the safety circuits.

The safety light beam Spot 10/35 is intended for use as part of a safety system to detect persons entering a

hazardous area. Safe signals are supplied to the control unit (Vital 1) that is controlling the safety outputs.

Warning! Spot 10/35 is not to be compiled as a light curtain to detect fingers or hands.

Warning!

Carefully read through this entire manual before using the device.

The devices shall be installed by a trained electrician following the Safety regulations, standards and the Machine

directive.

Failure to comply with instructions, operation that is not in accordance with the use prescribed in these instructions,

improper installation or handling of the device can affect the safety of people and the plant.

For installation and prescribed use of the product, the special notes in the instructions must be carefully observed

and the technical standards relevant to the application must be considered.

In case of failure to comply with the instructions or standards, especially when tampering with and/or modifying the

product, any liability is excluded.

2TLC172178M0201, rev. D

www.abb.com/lowvoltage

2011-11-15