Craden DP8 지원 데스크 매뉴얼 - 페이지 6

{카테고리_이름} Craden DP8에 대한 지원 데스크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Craden DP8 19 페이지. Transaction printers
Craden DP8에 대해서도 마찬가지입니다: 기술 매뉴얼 (8 페이지), 설치 매뉴얼 (2 페이지), 보충 설명서 (18 페이지)

페이지 인쇄

DP8 & DP9 RIBBON REPLACEMENT

Push in on cabinet latches

Rotate cabinet up and back.

Rotate cartridge down and out of

the printer

This close up shows how the ribbon is routed in step 5

above: over the tabs on the ribbon guide plate. If the

ribbon is routed below the tabs, printing problems will

occur.

(see the video at

www.craden.com/ribbonchg.wmv

Rotate lift ring forward to lift

and lock carriage.

RUBBER

WHEEL

RIBBON

PATH

TABS

Slip the new ribbon over and

behind guide plate tabs.

Push ribbon guide plate tabs

RIBBON

SHIELD

Rotate cartridge into place and snap in.

Rotate cartridge drive gear clockwise to

align and take up ribbon slack. Push

shield up. Lower carriage into operating

position. Close cabinet.

Generic Ribbons May Cause Problems

Note:

Our experience has found many "generic" ribbons cause

printer malfunctions. Generic ribbons may stick to the

ribbon guide mechanism and drag on the ribbon shield,

causing ribbon advance issues, poor print quality,

smearing, carriage stalls, and printhead failure.

Ribbons must have a specific fabric and ink combination to

run properly. The ink is matched to the thin printwires and

is applied to the ribbon in a specific amount that will not

foul the printwires with ink. Generic inks may contain solid

particles that cause excessive printwire wear. Generic

fabrics may shred and cause a buildup of lint on the

printhead. Printhead deterioration or failure caused by

improperly fabricated generic ribbons is not covered by

warranty

)

down.