Dell Precision Workstation 350 설치 매뉴얼 - 페이지 23

{카테고리_이름} Dell Precision Workstation 350에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Precision Workstation 350 32 페이지. Dell poweredge 350 servers: supplementary guide
Dell Precision Workstation 350에 대해서도 마찬가지입니다: 정보 업데이트 (30 페이지)

페이지 인쇄
Dell Precision Workstation 350 설치 매뉴얼
support.dell.com
3.
Remove the front door from the rack as shown in Figure 1-14.
a.
With the door open, lift out and fully retract all hinge pins.
b.
Once all the hinge pins have been lifted out and retracted, lift the door out.
hinge insert

Figure 1-14. Removing the 24-U Rack Doors

CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the
following steps:
1.
With the door open, lift out and fully retract all hinge pins.
2.
Remove the hinges and door brackets from the door frame.
3.
Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4.
Replace the rack door (see the section, "Replacing the Rack Doors," found later
in this guide).

Installing the Slide Assemblies in the Four-Post Rack

NOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.
hinge pin
hinge
Rack Installation Guide
1-17