Dell Studio 1735 서비스 매뉴얼 - 페이지 17

{카테고리_이름} Dell Studio 1735에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Studio 1735 48 페이지. Dell studio setting up
Dell Studio 1735에 대해서도 마찬가지입니다: 빠른 설정 (2 페이지), 컴퓨터 설정 (2 페이지)

페이지 인쇄
Dell Studio 1735 서비스 매뉴얼
Back to Contents Page
  Processor Heat Sink
Dell™ Studio 1735/1737 Service Manual 
  Removing the Processor Heat Sink
  Replacing the Processor Heat Sink
 
CAUTION:
Before working inside your computer, follow the safety instructions that shipped with your computer.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
 Removing the Processor Heat Sink
 
1. Follow the instructions in
Before You
 
2. Turn the computer over and remove the base cover (see
 
3. Loosen the three captive screws that secure the processor heat sink to the system board.
1
processor heat sink
 
4. Lift the processor heat sink off the computer.
 Replacing the Processor Heat Sink
 
CAUTION:
Before working inside your computer, follow the safety instructions that shipped with your computer.
 
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface.
NOTE:
The original pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink is replaced,
use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.
NOTE:
This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
 
1. Peel the backing off the thermal cooling pad and adhere the pad to the portion of the heat sink that covers the processor.
 
2. Place the processor heat sink on the system board.
 
3. Tighten the three captive screws that secure the processor heat sink to the system board.
 
4. Replace the base cover (see
 
5. Slide the battery into the bay until it clicks into place.
Begin.
Removing the Base
2
captive screw (3)
Replacing the Base
Cover).
Cover).