Dell Studio 1735 Servis Kılavuzu - Sayfa 17

Dizüstü Bilgisayar Dell Studio 1735 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Studio 1735 48 sayfaları. Dell studio setting up
Ayrıca Dell Studio 1735 için: Hızlı Kurulum (2 sayfalar), Bilgisayarınızın Kurulumu (2 sayfalar)

Sayfayı Yazdır

Back to Contents Page

Processor Heat Sink

Dell™ Studio 1735/1737 Service Manual

Removing the Processor Heat Sink

Replacing the Processor Heat Sink

CAUTION:

Before working inside your computer, follow the safety instructions that shipped with your computer.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface

(such as a connector on the back of the computer).

Removing the Processor Heat Sink

1. Follow the instructions in

Before You

2. Turn the computer over and remove the base cover (see

3. Loosen the three captive screws that secure the processor heat sink to the system board.

processor heat sink

4. Lift the processor heat sink off the computer.

Replacing the Processor Heat Sink

CAUTION:

Before working inside your computer, follow the safety instructions that shipped with your computer.

NOTICE:

To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your

computer's electronic components. You can do so by touching an unpainted metal surface.

NOTE:

The original pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink is replaced,

use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.

NOTE:

This procedure assumes that you have already removed the processor heat sink and are ready to replace it.

1. Peel the backing off the thermal cooling pad and adhere the pad to the portion of the heat sink that covers the processor.

2. Place the processor heat sink on the system board.

3. Tighten the three captive screws that secure the processor heat sink to the system board.

4. Replace the base cover (see

5. Slide the battery into the bay until it clicks into place.

Begin.

Removing the Base

captive screw (3)

Replacing the Base

Cover).