Dell Studio 1735 Servis Kılavuzu - Sayfa 15

Dizüstü Bilgisayar Dell Studio 1735 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Studio 1735 48 sayfaları. Dell studio setting up
Ayrıca Dell Studio 1735 için: Hızlı Kurulum (2 sayfalar), Bilgisayarınızın Kurulumu (2 sayfalar)

Sayfayı Yazdır
Dell Studio 1735 Servis Kılavuzu
Back to Contents Page
  Processor
Dell™ Studio 1735/1737 Service Manual 
  Removing the Processor
  Installing the Processor
 
CAUTION:
Before working inside your computer, follow the safety instructions that shipped with your computer.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
 
NOTICE:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
NOTICE:
To avoid damage to the processor, hold the screwdriver such that it is perpendicular to the processor when turning the cam screw.
 Removing the Processor
 
1. Follow the instructions in
Before You
 
2. Turn the computer over and remove the base cover (see
 
3. Remove the processor heat sink (see
 
NOTICE:
When removing the processor, pull it straight up. Be careful not to bend the pins on the processor.
 
NOTICE:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
4. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
The ZIF-socket cam screw secures the processor to the system board. Take note of the arrow on the ZIF-socket cam screw.
1
processor
4
ZIF-socket cam screw
 
5. Use a processor extraction tool to remove the processor.
 Installing the Processor
 
Begin.
Removing the Base
Removing the Processor Heat
2
pin-1 corner of processor
 
 
Cover).
Sink).
3
ZIF socket