Dell D560F 소유자 매뉴얼 - 페이지 16
{카테고리_이름} Dell D560F에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D560F 33 페이지. Emc vxrail appliances on poweredge servers
페이지 인쇄
Table 14. Back panel features of VxRail D Series appliance (continued)
Item
Features
8
LOM riser slot (PCIe slot 1)
9
USB 3.0 port (2)
10
VGA port
11
System status indicator cable port N/A
12
System identification button
13
Full height riser right slot (Riser 1,
PCIe, slot 2)
NIC indicator codes
Each NIC on the back of the system has indicators that provide information about the activity and link status. The activity LED
indicator indicates if data is flowing through the NIC, and the link LED indicator indicates the speed of the connected network.
Figure 10. NIC indicator codes
1. Link LED indicator
2. Activity LED indicator
Table 15. NIC indicator codes
Status
Link and activity indicators are off.
Link indicator is green, and activity indicator is blinking
green.
16
Dell EMC VxRail D Series overview
Icon
Description
N/A
Use the LOM riser slot for NIC expansion. The LOM riser
contains the OCP network card and is recommended for LAN
connectivity.
Use the USB 3.0 port to connect USB devices to the system.
These ports are 4-pin, USB 3.0-compliant.
Use the VGA port to connect a display to the system. For
more information about the supported VGA port, see the
Technical specifications section.
Enables you to connect the status indicator cable and view
system status when the CMA is installed.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and
hold the system ID button (for more than five seconds)
to enter the BIOS progress mode.
N/A
Use the card slot to connect full-height PCIe expansion cards
on the full height riser.
NOTE:
configuration only. For 2 CPU configurations, see the half
height right and left risers (Riser 1 and 2, PCIe slot 2 and
3).
Condition
The NIC is not connected to the network.
The NIC is connected to a valid network at its maximum port speed,
and data is being sent or received.
The full height riser is supported on the 1 CPU