Dell Dimension 2200 매뉴얼 - 페이지 12

{카테고리_이름} Dell Dimension 2200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 2200 50 페이지. Vga card installation instructions
Dell Dimension 2200에 대해서도 마찬가지입니다: 교체 매뉴얼 (9 페이지), 설치 지침 (1 페이지)

페이지 인쇄

10. Slide the drive assembly into the drive bay.

NOTICE:

Dell does not recommend routing cables over cards because the cables can restrict airflow, cause cooling problems, and interfere with

removing and replacing the computer cover. If you must route cables over cards, be extremely cautious when removing and replacing the computer

cover.

11. If you are installing a controller card, configure and

Install the card as close as you can to the drive cage.

12. Connect a power cable to the drive.

NOTICE:

When you attach the extra connector to the new drive in the following step, match the colored strip on the cable with pin 1 on the drive.

13. If you didn't install a controller card in step 11, remove the tape from the wide cable connector and reattach the connector to the original drive. Then

locate the extra connector on the cable and attach it to the new drive. Be sure that the wide cable is properly connected to the IDE connector on the

system board.

If you installed a controller card in step 11, attach the other end of the interface cable to the controller card rather than to the system board.

install it in a connector slot

now.