Dell Dimension 2200 Посібник - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник для Сервер Dell Dimension 2200. Dell Dimension 2200 50 сторінок. Vga card installation instructions
Також для Dell Dimension 2200: Посібник із заміни (9 сторінок), Інструкція з монтажу (1 сторінок)
Друкувати сторінку
10. Slide the drive assembly into the drive bay.
NOTICE:
Dell does not recommend routing cables over cards because the cables can restrict airflow, cause cooling problems, and interfere with
removing and replacing the computer cover. If you must route cables over cards, be extremely cautious when removing and replacing the computer
cover.
11. If you are installing a controller card, configure and
Install the card as close as you can to the drive cage.
12. Connect a power cable to the drive.
NOTICE:
When you attach the extra connector to the new drive in the following step, match the colored strip on the cable with pin 1 on the drive.
13. If you didn't install a controller card in step 11, remove the tape from the wide cable connector and reattach the connector to the original drive. Then
locate the extra connector on the cable and attach it to the new drive. Be sure that the wide cable is properly connected to the IDE connector on the
system board.
If you installed a controller card in step 11, attach the other end of the interface cable to the controller card rather than to the system board.
install it in a connector slot
now.