Dell Dimension 2400 Series 설치 매뉴얼 - 페이지 19

{카테고리_이름} Dell Dimension 2400 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 2400 Series 20 페이지. Vga card installation instructions
Dell Dimension 2400 Series에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 설치 매뉴얼 (8 페이지), 랙 설치 지침 (32 페이지), 설치 지침 (1 페이지), 매뉴얼 (43 페이지)

페이지 인쇄
Dell Dimension 2400 Series 설치 매뉴얼
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
support.dell.com
5HSODFLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
To install the replacement SEC cartridge and heat sink assembly, perform the follow-
ing steps:
1.
Remove the terminator card or old SEC cartridge from the guide bracket
assembly.
2.
Slide the SEC cartridge and heat sink assembly into the guide-bracket assembly
until the edge connector on the SEC cartridge is firmly seated in the connector on
the system board (see Figure 1-8).
3.
Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the SEC car-
tridge and heat sink assembly in the bracket.
4.
Replace the cooling shroud and computer cover.
guide bracket assembly
)LJXUH 5HSODFLQJ DQ 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
DELL CONFIDENTIAL - Preliminary
heat sink
SEC cartridge
9/11/00
Microprocessor Upgrade Installation Guide
retention clips (2)
latches (2)
1-15