Dell Dimension 2400 Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Dell Dimension 2400 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 2400 Series 20 페이지. Vga card installation instructions
Dell Dimension 2400 Series에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 설치 매뉴얼 (8 페이지), 랙 설치 지침 (32 페이지), 설치 지침 (1 페이지), 매뉴얼 (43 페이지)

페이지 인쇄
Dell Dimension 2400 Series 설치 매뉴얼
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-4
Microprocessor Upgrade Installation Guide
,QVWDOOLQJ DQ 8SJUDGH 0LFURSURFHVVRU LQ
3RZHU(GJH 6\VWHPV
This section provides instructions for:
‡
Removing the cooling shroud, single-edge contact (SEC) cartridge, and heat sink
‡
Installing the new SEC cartridge and heat sink and replacing the cooling shroud
‡
Reassembling and checking the system
5HPRYLQJ WKH &RROLQJ 6KURXG 6(& &DUWULGJH DQG
+HDW 6LQN
1.
Turn off the system, including any attached peripherals, and disconnect the power
cable from the electrical outlet.
2.
Remove the right-side system cover and bezel.
See your system Installation and Troubleshooting Guide for specific instructions,
if needed.
3.
Remove the cooling shroud as follows:
a.
Unscrew and remove the two retention pins (see Figure 1-1).
b.
Remove the shroud by lifting the end of the shroud closest to the micropro-
cessor(s) until the opposite end of the shroud disengages from the cooling
fan on the system's back panel (see Figure 1-1).
DELL CONFIDENTIAL - Preliminary
9/11/00