Dell EMC VxRail E560F 소유자 매뉴얼 - 페이지 19

{카테고리_이름} Dell EMC VxRail E560F에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC VxRail E560F 35 페이지. Appliances on poweredge servers

Figure 10. DC PSU status indicator

1. DC PSU status indicator

Table 17. DC PSU status indicators

Convention

Power indicator pattern

Green

Flashing green

Flashing amber

Not lit

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC

subsystem.

NOTE:

The iDRAC Direct LED indicator does not turn on when the USB port is used in the USB mode.

Condition

A valid power source is connected to the PSU and that the PSU is

operational.

When hot-adding a PSU, the PSU indicator flashes green. This indicates

that there is a PSU mismatch with respect to efficiency, feature set, health

status, and supported voltage. Ensure that both the PSUs are of the same

capacity.

Indicates a problem with the PSU.

CAUTION:

When correcting a PSU mismatch, replace only the

PSU with the flashing indicator. Swapping the PSU to make a

matched pair can result in an error condition and unexpected

appliance shutdown. To change from a High Output configuration

to a Low Output configuration or vice versa, you must turn off

the appliance.

CAUTION:

If two PSU are used, they must be of the same type

and have the same maximum output power.

CAUTION:

Combining AC and DC PSU is not supported and

triggers a mismatch.

Power is not connected.

Overview