Dell Force10 MXL Blade 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Dell Force10 MXL Blade에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 MXL Blade 38 페이지. 10/40gbe blade switches
Dell Force10 MXL Blade에 대해서도 마찬가지입니다: 애플리케이션 노트 (6 페이지), 사양 (2 페이지), 매뉴얼 (27 페이지)

페이지 인쇄

Before you start, to perform the initial switch configuration, you must obtain

the following information from your network administrator:

•

The IP address to be assigned to the out-of-band (OOB) interface for

device management.

•

The IP subnet mask for the OOB interface.

•

The IP address of the OOB interface default gateway.

These settings are necessary to allow remote management of the switch

through a Telnet (Telnet client) or HTTP (Web browser) connection.

NOTE:

The switch is configured with a default user name (root) and password

(calvin).

Initial Configuration Procedure

Perform the initial configuration from the connected console by using the

Dell Easy Setup Wizard or by using the CLI.

The wizard automatically starts when there is no startup configuration file on

the switch. You can exit the wizard at any point by entering [Ctrl+c], but all

configured settings will be discarded and the switch will use the default values

displayed in parentheses in the wizard; for example,

NOTE:

If you do not run the Easy Setup Wizard or do not respond to the initial Easy

Setup Wizard prompt within 60 seconds, the switch enters CLI mode and the default

configuration values are applied.

For more information about how to perform the initial configuration using

the CLI, refer to the Dell Force10 FTOS Configuration Guide for the Dell

Force10 MXL 10/40GbE Switch IO Module.

This Getting Started Guide describes how to use the Easy Setup Wizard for

initial switch configuration. The wizard sets up the following configuration

on the switch:

•

Establishes the initial privileged user account with a valid password. The

wizard configures one privileged user account during the setup.

•

Sets up the IP address for the OOB interface.

•

Sets up the SNMP community string to be used by the SNMP manager at

a given IP address. You may choose to skip this step if SNMP management

is not used for this switch.

Installing and Configuring the Switch

[public