Dell M3S2G8 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Dell M3S2G8에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell M3S2G8 32 페이지. Servers for sap hana

Power on the server to standby

Steps

1. Request the customer to plug each PDU into the site power supply. The server is now connected to the site power supply

and is ready to be powered on to standby.

2. Request the customer to turn the site power breakers ON.

3. On each server module, check that the power status LED (A) on the Management Board Right Side (MRB) is blinking green.

Figure 7. Power status LED - front view

Steps

1. Wait a few seconds.

2. Check that the switch Ethernet One Gigabit (WEO) power LED (F) is green and the activity LEDs (E) of the powered

modules are green.

3. Check that the PHY Ethernet Board (PEB) or PHY Ethernet Board SFP+ (PEBS) identification LED (A) is on.

4. Check the PEB or PEBS Ethernet link LEDs (C) are on when a cable is connected.

Connecting the Server