Dell PowerEdge 1300 업그레이드 매뉴얼 - 페이지 22

{카테고리_이름} Dell PowerEdge 1300에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 1300 23 페이지. Video update
Dell PowerEdge 1300에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (24 페이지), 업데이트 매뉴얼 (2 페이지)

페이지 인쇄

support.dell.com

!") &% '"

To reassemble the system and perform verification checks, perform the following

steps.

NOTE: The following procedures apply to PowerEdge 2300, 4300, and 4350 systems.

For PowerEdge 1300 systems, see step 7 under "Installing Upgrade Microprocessors

in the PowerEdge 1300", found earlier in this document.

Close the computer panel doors (for PowerEdge 4350 systems only) or replace

the covers and front bezel, and reconnect your computer and peripherals to their

power sources and turn them on.

As the system boots, it detects the presence of the new microprocessor and

automatically changes the system configuration information in the System Setup

program. The following message appears:

Second processor detected

Enter the System Setup program and confirm that the top line in the system data

area correctly identifies the installed microprocessor(s). By default, the serial

numbers of Pentium III microprocessors are not displayed. See the procedures in

"Using the System Setup Program" in your User's Guide for accessing and mod-

ifying entries in the System Setup screens.

Reset the chassis intrusion detector while in the System Setup program by

changing Chassis Intrusion to Not Detected.

NOTE: If a setup password has been assigned by someone else, contact your

network administrator for information on resetting the chassis intrusion detector.

Run the Dell Diagnostics to verify that the new microprocessor is operating

correctly.

See your User's Guide and your Installation and Troubleshooting Guide for addi-

tional information on running the Dell Diagnostics and troubleshooting any

problems that may occur.

Dell PowerEdge Systems — Microprocessor Upgrade

1-19