Dell PowerEdge 2400 활성화 매뉴얼 - 페이지 5
{카테고리_이름} Dell PowerEdge 2400에 대한 활성화 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2400 8 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2400에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (8 페이지), 랙 설치 지침 (32 페이지), 업데이트 (2 페이지), 설치 매뉴얼 (8 페이지), 업데이트 매뉴얼 (2 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
1
DIMM socket ejectors (2)
2
Alignment keys (2)
5.
Align the DIMM's edge connector with the slot in the center of the DIMM
socket, and insert the DIMM in the socket (see step A in Figure 1-2).
The DIMM socket has two alignment keys that allow the DIMM to be installed in
the socket in only one way.
NOTE: The RAID controller DIMM must be an unbuffered DIMM, rated to run at
100 MHz. Do not substitute registered DIMMs such as those used for system
memory. System memory is labeled "PC133."
6.
Press down on the DIMM with your thumbs while pulling up on the ejectors with
your index fingers to lock the DIMM into the socket (see step B in Figure 1-2).
7 .
Install the RAID hardware key in its socket on the system board (see Figure 1-1).
Secure the key with the latches on each end of the socket (see Figure 1-3). The
RAID hardware key should be labeled "PE2400."
Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si
1-3