Dell PowerEdge 2400 Instrukcja aktywacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja aktywacji dla Serwer Dell PowerEdge 2400. Dell PowerEdge 2400 8 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 2400: Instrukcja instalacji (20 strony), Instrukcja instalacji (8 strony), Instrukcja instalacji stojaka (32 strony), Aktualizacja (2 strony), Instrukcja instalacji (8 strony), Aktualizacja instrukcji (2 strony), Podręcznik (15 strony)

DIMM socket ejectors (2)

Alignment keys (2)

Align the DIMM's edge connector with the slot in the center of the DIMM

socket, and insert the DIMM in the socket (see step A in Figure 1-2).

The DIMM socket has two alignment keys that allow the DIMM to be installed in

the socket in only one way.

NOTE: The RAID controller DIMM must be an unbuffered DIMM, rated to run at

100 MHz. Do not substitute registered DIMMs such as those used for system

memory. System memory is labeled "PC133."

Press down on the DIMM with your thumbs while pulling up on the ejectors with

your index fingers to lock the DIMM into the socket (see step B in Figure 1-2).

7 .

Install the RAID hardware key in its socket on the system board (see Figure 1-1).

Secure the key with the latches on each end of the socket (see Figure 1-3). The

RAID hardware key should be labeled "PE2400."

Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si

1-3