Dell PowerEdge 2410 매뉴얼 - 페이지 5

{카테고리_이름} Dell PowerEdge 2410에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2410 10 페이지. Cabling poweredge t610
Dell PowerEdge 2410에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지), 매뉴얼 (11 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Cabling the Dell™ PowerEdge™ R610

2.2 Route the Power Cables through the Strain Reliefs

After the tray and cables are installed, route the power cables through the strain reliefs located on the power

supply handles as shown in Figure 2.

Figure 2: Routing Power Cables through the Strain Reliefs

2.3 Routing the Cables through the CMA

NOTE: The CMA can be installed on either the right or left rear side of the rails. Mounting the CMA on the side

opposite the power supplies (left side mount) is recommended; otherwise, the CMA must be disconnected in order

to remove the outer power supply. Refer to "Replacing a Power Supply on a PowerEdge R610 with CMA" later in

this white paper for details on power supply replacement.

NOTE: For guidelines on how to route cables within the rack, refer to the Dell White Paper "Best Practices Guide

for Rack Enclosures".

Left Side Mounting Instructions

1. Install the CMA on the left rear side of the rails by attaching both CMA housings to the attachment brackets on

the rails. See Figure 3.

2. Route the cables through the CMA while keeping any twisting of the cables to a minimum. Use the hook and

loop straps on the CMA to secure the cables.

Page 3