Dell PowerEdge 2410 매뉴얼 - 페이지 10

{카테고리_이름} Dell PowerEdge 2410에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2410 12 페이지. Cabling poweredge t610
Dell PowerEdge 2410에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지), 매뉴얼 (11 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Cable Routing Procedures for Dell™ PowerEdge™ R415 Systems

Figure 9: Removing the CMA Brackets for Shallow Racks

Section 3: Replacing a Power Supply on a PowerEdge™ R415 System With a

CMA

Remove the tray from underneath the CMA as described in the

provided with the CMA kit.

2. Swing the CMA into the service position.

3. Disengage the strain relief and disconnect the power cord from the power supply.

4. If the CMA is attached to the left side, both power supplies can be removed without

disconnecting the CMA.

5. If the CMA is attached to the right side and the inner power supply needs to be replaced, the

CMA does not need to be disconnected.

6. If the CMA is attached to the right side and the outer power supply needs to be replaced:

a. Disconnect the inner CMA bracket from the rail as shown in Figure 10.

b. While supporting the CMA with one hand, remove and replace the power supply with

the other hand as shown in Figure 11.

c. Reinstall the inner CMA bracket to reconnect the CMA.

7. After the power supply has been replaced, plug in the power cord, re-engage the strain relief,

replace the CMA support tray, and return the CMA to the closed (retracted) position.

CMA Installation Instructions

Page 8