Dell PowerEdge 2450 정보 업데이트 - 페이지 12

{카테고리_이름} Dell PowerEdge 2450에 대한 정보 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2450 12 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2450에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (20 페이지), 보충 설명서 (30 페이지), 하드웨어 설치 매뉴얼 (32 페이지), 소프트웨어 설명서 (10 페이지), 설치 매뉴얼 (8 페이지), 매뉴얼 (15 페이지)

1-10

Dell PowerEdge 2450 Systems Information Update

heat sink

guide-bracket

assembly

% '!"!#

$ %&

Replace the air blower, if it was removed in step 3 of the previous procedure (see

Figure 1-3).

Position your right thumb on the outside of the power supply enclosure

beside the narrower front part of the air blower.

Push firmly on the power supply enclosure to move it slightly toward the

power supplies, allowing extra clearance to install the air blower.

Hold the air blower above the heat sink while tilting the back of the air blower

slightly down and toward the back of the chassis.

Slide the metal tab at the back right of the air blower carefully into the

topmost slot at the top back of the chassis.

With your left hand, push down firmly on the front of the air blower until you

hear it snap into place.

Make sure that the top of the air blower is level; if it is not level, lift out the air

blower and reinstall it making sure the tab goes into the slot at the very top

of the back chassis.

Plug in the Y -shaped blower power cable to the connector on the interposer

board.

Replace the system cover.

Reconnect your system and peripherals to their power sources.

SEC cartridge

tab