Dell PowerEdge 2450 정보 업데이트 - 페이지 5

{카테고리_이름} Dell PowerEdge 2450에 대한 정보 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2450 12 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2450에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (20 페이지), 보충 설명서 (30 페이지), 하드웨어 설치 매뉴얼 (32 페이지), 소프트웨어 설명서 (10 페이지), 설치 매뉴얼 (8 페이지), 매뉴얼 (15 페이지)

Dell PowerEdge 2450 정보 업데이트
support.dell.com
7 .
Install the new expansion card.
Position the expansion-card cage so that the riser board lies horizontally on your
work surface.
Insert the card-edge connector firmly into the expansion-card connector on the
riser board, until the card is fully seated.
8.
When the card is seated in the connector and the card-mounting bracket is
aligned with the brackets on either side of it, close the expansion-card latch.
9.
If the expansion card is a full-length card, secure the inner end of the card by
closing the latch on the card guide over the top edge of the card.
10. With the securing lever in the upright position, lower the expansion-card cage
into place until it is aligned.
11. Rotate the securing lever downward until it is flush with the top of the chassis.
Make sure the riser board is fully seated in the RISER connector on the system
board.
12. Reconnect any cables you removed in step 3.
See the documentation that came with the card for information about its cable
connections.
13. Close the system doors, and then reconnect the system and peripherals to their
AC power sources and turn them on.
To remove an expansion card, perform the following steps:
1.
To release the expansion card from the card cage, rotate the expansion-card latch
away from the expansion-card bracket.
2.
If the expansion card is a full-length card, release the card's inner end by opening
the tab on the card guide (see Figure 1-2).
3.
Grasp the expansion card by its top corners, and carefully remove it from the
expansion-card connector.
4.
If you are removing the card permanently, install a metal filler bracket over the
empty card-slot opening.
NOTE: Installing a filler bracket over an empty expansion slot is necessary to
maintain Federal Communications Commission (FCC) certification of the system.
The brackets also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
5.
Replace the expansion-card cage in the chassis as instructed in steps 10 through
12 of the previous procedure.
6.
Close the system doors, and then reconnect the system and peripherals to their
AC power sources and turn them on.
Dell PowerEdge 2450 Systems Information Update
1-3