Dell PowerEdge 4400 설치 매뉴얼 - 페이지 8

{카테고리_이름} Dell PowerEdge 4400에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 4400 36 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 4400에 대해서도 마찬가지입니다: 설치 매뉴얼 (42 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (28 페이지), 랙 설치 (37 페이지), 업데이트 매뉴얼 (8 페이지), 정보 업데이트 (8 페이지), 사용자 설명서 (42 페이지), 랙 설치 (34 페이지), 하드웨어 설치 매뉴얼 (40 페이지), 매뉴얼 (15 페이지)

페이지 인쇄
Dell PowerEdge 4400 설치 매뉴얼
1-4
Dell PowerEdge Systems — Installing the External Drive Bay
SCSI hard-disk
drives in external
drive-bay
assembly
SCSI cable
with terminator
SCSI backplane
cable connector
Figure 1-2. Attaching the SCSI Cable
5.
Attach the power cable(s) to the power connector(s) on the back of the drive bay
assembly.
6.
Install the system management ribbon cable (provided with the kit):
a.
Remove the ribbon cable from the SCSI backplane board interface connector
(the BACKPLANE connector) on the system board. Do not disconnect the
other end of this cable from its connector on the SCSI backplane board.
b.
Locate the system management ribbon cable (provided with the kit). Con-
nect the end of this cable, marked PLANAR, to the BACKPLANE connector
on the system board.
c.
Attach the free end of the cable you disconnected in step a. to the middle
connector of the system management ribbon cable you just installed in step
b. Secure the connectors with latches on the new system management
cable connector.
d.
Attache the system management cable connector marked FDHDBP to the
connector labeled PLANAR 1X2 on the back of the drive bay assembly.
terminator
SCSI connector
(PRIMARY SCSI-A)
SCSI connector
(PRIMARY SCSI-B)