Dell PowerEdge 4400 Kurulum Kılavuzu - Sayfa 8

Sunucu Dell PowerEdge 4400 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 4400 36 sayfaları. Wake-on-lan (wol) support on dell servers
Ayrıca Dell PowerEdge 4400 için: Kurulum Kılavuzu (42 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (28 sayfalar), Raf Kurulumu (37 sayfalar), Güncelleme Kılavuzu (8 sayfalar), Bilgi Güncellemesi (8 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Raf Kurulumu (34 sayfalar), Donanım Kurulum Kılavuzu (40 sayfalar), Manuel (15 sayfalar)

Sayfayı Yazdır
Dell PowerEdge 4400 Kurulum Kılavuzu
1-4
Dell PowerEdge Systems — Installing the External Drive Bay
SCSI hard-disk
drives in external
drive-bay
assembly
SCSI cable
with terminator
SCSI backplane
cable connector
Figure 1-2. Attaching the SCSI Cable
5.
Attach the power cable(s) to the power connector(s) on the back of the drive bay
assembly.
6.
Install the system management ribbon cable (provided with the kit):
a.
Remove the ribbon cable from the SCSI backplane board interface connector
(the BACKPLANE connector) on the system board. Do not disconnect the
other end of this cable from its connector on the SCSI backplane board.
b.
Locate the system management ribbon cable (provided with the kit). Con-
nect the end of this cable, marked PLANAR, to the BACKPLANE connector
on the system board.
c.
Attach the free end of the cable you disconnected in step a. to the middle
connector of the system management ribbon cable you just installed in step
b. Secure the connectors with latches on the new system management
cable connector.
d.
Attache the system management cable connector marked FDHDBP to the
connector labeled PLANAR 1X2 on the back of the drive bay assembly.
terminator
SCSI connector
(PRIMARY SCSI-A)
SCSI connector
(PRIMARY SCSI-B)