Dell PowerEdge 850 정보 업데이트 - 페이지 2

{카테고리_이름} Dell PowerEdge 850에 대한 정보 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 850 18 페이지. Information update - dell openmanage server support kit version 4.3 (.pdf)
Dell PowerEdge 850에 대해서도 마찬가지입니다: 시스템 진단 정보 업데이트 (2 페이지), 설치 매뉴얼 (28 페이지), 사용자 설명서 (23 페이지)

페이지 인쇄

Figure 1. Installing and Removing the PCI Fan Module

PCI fan

intrusion switch connector

Installing the PCI Fan Module

1 Place the PCI fan module over the mounting holes in the system chassis and install the two screws to

connect the mounting bracket to the chassis. See Figure 1.

2 Connect the chassis intrusion switch to the INTRUSION_SWITCH connector on the system board.

3 Connect the fan module's power cable to the connector on the system fan assembly.

4 Route the cables connected to the daughter card through the slot on the mounting bracket.

5 Close the system. See "Closing the System" in the Installation and Troubleshooting Guide.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of Dell Inc.; Red Hat is a registered trademark

of Red Hat, Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names

or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

screws (2)

fan power cable

chassis intrusion switch