Dell PowerEdge FD332 소유자 매뉴얼 - 페이지 41

{카테고리_이름} Dell PowerEdge FD332에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge FD332 46 페이지.
Dell PowerEdge FD332에 대해서도 마찬가지입니다: 시작하기 (2 페이지)

NOTE:

You cannot run diagnostics tests on PowerEdge FD332. You must run system diagnostics from the compute sled(s) to

which PowerEdge FD332 is mapped.

If you experience a problem with your system, run the system diagnostics before contacting Dell for technical assistance. The purpose of

running system diagnostics is to test your system hardware without requiring additional equipment or risking data loss. If you are unable to

fix the problem yourself, service and support personnel can use the diagnostics results to help you solve the problem.

NOTE:

You cannot run diagnostics tests on PowerEdge FD332. You must run system diagnostics from the compute sled(s) to

which PowerEdge FD332 is mapped.

NOTE:

The Dell Embedded System Diagnostics is also known as Enhanced Pre-boot System Assessment (ePSA) diagnostics.

The Embedded System Diagnostics provides a set of options for particular device groups or devices allowing you to:

•

Run tests automatically or in an interactive mode

•

Repeat tests

•

Display or save test results

•

Run thorough tests to introduce additional test options to provide extra information about the failed device(s)

•

View status messages that inform you if tests are completed successfully

•

View error messages that inform you of problems encountered during testing

If a major component or device in the system does not operate properly, running the Embedded System Diagnostics may indicate

component failure.

Running the Embedded System Diagnostics from Boot

Manager

As the system boots, press <F11>.

Use the up and down arrow keys to select System Utilities > Launch Diagnostics.

The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the system. The diagnostics starts

executing the tests on all the detected devices.

Using system diagnostics